Scrap standards for lifting straps

Use it correctly, be kind to life, strictly prohibit overloading, and replace it frequently.

Scrap standards for lifting straps:

A. The lifting belt becomes fibrous, softens, becomes less elastic, and becomes weaker in strength.

B. The load-bearing seams bloom and the sutures are worn out.

C. The surface of the lifting belt is rough and easy to peel off, and there are holes, cuts, and tears on the surface of the lifting belt.

D. There are excessive point-like looseness, corrosion, acid and alkali burning, thermal melting or scorching on the surface of the lifting belt.

E. If there is a dead knot in the lifting belt, it should not be untied.

F. The normal use cycle is 6 months.Infrequent use can be extended to 12 months.

Use and maintenance of lifting straps:

A. The correct method coefficient must be used and cannot be overloaded.

B. Make sure the sling is not damaged before each use of the spreader.

C. Round slings are susceptible to mechanical, chemical, and high temperature damage. If the protective layer is seriously damaged, they must not be used.

D. Use protective objects to separate the corners of the sling and the load.

E. Round or flat slings must not be knotted.

F. When hoisting, the sling and load must not be dragged.

G. Avoid impact or vibration of the load, and take off and land smoothly.

H. Dangerous slings do not need to be repaired.

I. Lifting straps and rigging should be stored in a ventilated and dry place and should not be exposed to organic acids.